Search results

Create the page "HFI Data processing" on this wiki! See also the search results found.

• HelpForBook
  Where DPC is one of HFI or LFI, x_x_x_x the section number for the page where the image will be dis ...would be named ''LFI_2_3_someName.png'' and a jpeg figure uploaded by the HFI to be displayed in section 6.4.3.1 would be named ''HFI_2_3_someOtherName.j
  31 KB (5,455 words) - 18:41, 16 March 2013
• HFI Detector Spectral Response
  = HFI Detector Spectral Response = ...dband Fourier transform spectrometer (FTS) measurements conducted with the HFI focal plane assembly as described above, and includes a waveguide model for
  58 KB (7,853 words) - 15:51, 5 October 2012
• The RIMO
  ...apers|planck2014-a08}}). There are two RIMOs, one for each instrument (the HFI RIMO consists of several parts), which follow the same overall structure, b The type of data in the RIMO can be of several forms.
  38 KB (5,921 words) - 11:50, 22 June 2021
• TOI processing
  ...elease), the main change with respect to 2015 has been in the selection of data: the last 955 pointings (or rings) have not been used because they have bee Detailed explanations of each stage of the TOI processing are given in various papers, referenced in the diagram below (taken from {{
  20 KB (3,054 words) - 14:18, 2 July 2018
• The Planck mission
  data of a quality adequate to measure the CMB signal and distinguish it from oth all the data into usable scientific products. At the end of the mission the consortia de
  13 KB (2,044 words) - 09:08, 21 August 2013
• The satellite
  ...diation from the sky onto a focal plane shared by detectors of the LFI and HFI, operating at 20K and 0.1K respectively; a telescope baffle that simultaneo |'''On-board data storage capacity'''
  14 KB (2,170 words) - 09:29, 21 May 2014
• Ground Segment and Operations
  ...g (HK) data acquired by the satellite during the past 24 h. The downlinked data were typically 8 h; at MOC they were put onto a data server from
  21 KB (3,189 words) - 09:23, 10 July 2018
• Data processing
  ...he [[The LFI DPC|LFI]], and also the [[HFI/LFI joint data processing|joint processing]].
  337 bytes (57 words) - 09:33, 10 July 2018
• Power spectra
  [[Category:HFI data processing|007]]
  189 bytes (27 words) - 15:16, 4 February 2015
• Pre-processing LFI
  {{DISPLAYTITLE:Pre-processing}} The first processing level of the LFI DPC is Level 1. The input data for the Level 1 software includes:
  15 KB (2,441 words) - 15:41, 4 July 2018
• HFI cryogenics
  The HFI dilution cooler cools the bolometers down to 0.1 K through ...FI_2_4_1_overal_cryo.jpg|thumb|500px|center|Thermal architecture of Planck-HFI.]]
  5 KB (754 words) - 07:49, 6 July 2018
• HFI-Validation
  * spectra of the PR2 and the PR3 data splits, * comparison of the FFP10 simulations and the PR3 data.
  6 KB (1,057 words) - 08:40, 3 July 2018
• HFI sims
  {{DISPLAYTITLE:HFI simulations}} ...ines with the same algorithms (and when possible, codes) as for the flight data.
  29 KB (4,250 words) - 13:56, 2 July 2018
• Map-making LFI
  The conversion was applied to the input pointing data, prior to the construction of the map. ...solution data set is therefore required for the low-ℓ analysis. This data set has been packed into three different files, one per frequency, called "
  21 KB (3,331 words) - 16:04, 6 July 2018
• HFI/LFI joint data processing
  The HFI / LFI common processing uses as basic input the maps at the nine frequencies covered by the two ins ...code (of a particular theoretical <i>C</i>_&#8467; given Planck data).
  675 bytes (92 words) - 09:44, 10 July 2018
• C2
  The main product to express cosmological constraints imposed by Planck data is a likelihood code. One of its by-products is the derived maximum-likelih [[Category:HFI/LFI joint data processing|004]]
  675 bytes (89 words) - 06:35, 12 January 2017
• Beams LFI
  ...ing strategy, coupled to the beam asymmetries in the focal plane, and data processing of the bolometer and radiometer TOIs, the resulting Planck effective beams * create a data object of all beams pointed at all <i>N</i>_pix directions of pix
  23 KB (3,593 words) - 15:15, 9 November 2018
• References
  title = {Planck 2013 results: The Low Frequency Instrument data processing (p02)}, title = {Planck 2013 results: High Frequency Instrument Data Processing (p03)},
  173 KB (25,381 words) - 15:29, 4 June 2014
• HL-sims
  The Level S (<tt>LS</tt> in short) is a generic simulation tool common to HFI and LFI. One version was described in [[ref to the old LS paper]]. It can t ...more extensive instrument specific simulation environment. For HFI, see [[HFI-Validation#sims]].
  5 KB (779 words) - 16:03, 21 May 2014
• Mission products
  To support the interpretation of these data, these products are accompanied by: * instrument-level data (beam properties, noise levels, bandpass profiles, and more) compiled into
  3 KB (438 words) - 21:53, 4 July 2015

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)