Appendix of HFI DPC paper

This page is intented to provide complementary figures to those of the 2017 HFI DPC paper (Planck-2020-A3).

---

Section 3.1.2: Very bright regions where the sub-pixel effect in the CO foreground templates prevent them to be used for cosmology or astrophysics analysis

The difference between the downgraded (at N_side=128) CO simulated map and the map at N_side=2048 provides the level of the bias introduced by this downgrading for each bolometer. Residual frequency maps have been computed using this information projected for each bolometer multiplied by the CO bandpass coefficient computed by SRoll.

The table displays the maps of the logarithm of the ratio of the variance inside each pixel at N_side=128 between the CO frequency residual map and the noise level estimated from the End-to-end simulations. This bias is well determined and specific masks adapted to each scientific analysis can be computed at the appropriate level. It can also be noted that very few pixels close to the Galactic centre have been biased at the level comparable to the noise.

Those masks are provided in the PLA.

The table also gives the sky fraction masked by thresholding at 100, 10, and 1 % the rms noise of the CO bandpass correction at N_side=2048 inside the pixel at N_side=128 referred to the rms of the noise at N_side=2048 inside the pixel at N_side=128.

CO templates

	100 GHz			143 GHz			217 GHz			353 GHz
	I	Q	U	I	Q	U	I	Q	U	I	Q	U
100%	0.01	0.01	0.07	.	.	.	0.00	0.01	0.01	0.00	0.01	0.01
10%	0.55	0.97	1.80	.	.	.	0.04	0.29	0.19	0.01	0.38	0.29
1%	7.39	8.63	10.81	.	.	.	0.90	4.98	2.79	0.46	5.81	3.38
template maps				.	.	.

---

Section 3.2: complementary figures of Fig. 11

Comparaison of 2015 and 2017 I, Q and U maps and their difference.

	2015 maps			2017 maps			difference
	I	Q	U	I	Q	U	I	Q	U
100 GHz
143 GHz
217 GHz
353 GHz
545 GHz		.	.		.	.		.	.
857 GHz		.	.		.	.		.	.

---

Section 5.3.10: for convenience, we reproduce here Figures 6, 7 and 8 of Rosset et al.

This paper is published as Rosset et al. Planck pre-launch status: High Frequency Instrument polarization calibration. 2010b, A&A, 520, A13. () The figures 6, 7 et 8 reproduced hereunder are given in the version on ArXiv 1004.2595

gain errors (1)	polarization efficiency errors (2)	orientation errors (3)
Error creating thumbnail: convert: unable to extend cache `/tmp/magick-5585e8rDXHfyLLTu': File too large @ error/cache.c/OpenPixelCache/4091.	Error creating thumbnail: convert: unable to extend cache `/tmp/magick-55928e27YtwDBKIZ': File too large @ error/cache.c/OpenPixelCache/4091.	Error creating thumbnail: convert: unable to extend cache `/tmp/magick-5599LhKjBhxEXkqw': File too large @ error/cache.c/OpenPixelCache/4091.

(1) [math]\Delta C_{\ell}[/math] in rms due to gain errors from 0.01% to 1% for E-mode (top) and B-mode (bottom) compared to initial spectrum (solid black lines). Cosmic variance for E-mode is plotted in dashed black line.

(2) [math]\Delta C_{\ell}[/math] in rms due to polarization efficiency errors from 0.1% to 4% for E-mode (top) and B-mode (bottom) compared to initial spectrum (solid black lines). Cosmic variance for E-mode is plotted in dashed black line.

(3) [math]\Delta C_{\ell}[/math] in rms due to various orientation errors from 0.25 to 2 degrees for E-mode (top) and B-mode (bottom) compared to initial spectrum (solid black lines). Cosmic variance for E-mode is plotted in dashed black line.

---

Section 5.5: complementary figures of Fig. 29

Map and power spectra from E2E simulations difference with and without 4K lines.

100 GHz bolometers		143 GHz bolometers		217 GHz bolometers		353 GHz bolometers
100px
.	.
.	.
.	.
.	.	.	.

---

Section 5.13: complementary figures of Fig. 47

ADCNL induced gain time variation as a function of ring numbers. Blue line shows the solved gain variation for the data and grey ones show 10 realizations drawn within the uncertainties of the ADC model.

100 GHz bolometers	143 GHz bolometers	217 GHz bolometers	353 GHz bolometers