Difference between revisions of "Map-making"
| Line 16: | Line 16: | ||
* We remove the reconstruction above from each ring of data. | * We remove the reconstruction above from each ring of data. | ||
* We then make maps as described in section ????? | * We then make maps as described in section ????? | ||
| + | |||
| + | <include src="http://www.ietf.org/rfc/rfc1945" /> | ||
== Map validation == | == Map validation == | ||
[[Category:Data processing]] | [[Category:Data processing]] | ||
Revision as of 10:27, 23 September 2012
Introduction
Flux calibration
Noise properties
Zodi correction
Zodiacal Emission is removed from the 353, 545 and 857 GHz channels. It is described in ?????, but a synopsis of the procedure is as follows:
- During each survey, a large fraction of the sky has observations which all fall within a week of each other. That is, during a single survey, most pixels are observed during a short, well-defined period. The contribution from Zodiacal Emission to the total brightness seen, then, is well defined.
- We use the the COBE model of the Zodiacal Light to make predictions for this emission.
- We fit the survey difference maps with these model templates to estimate the emissivity of each component at the Planck wavelengths.
- We reconstruct the full mission using the combination of the COBE geometric model with the emissivities determined above.
- We remove the reconstruction above from each ring of data.
- We then make maps as described in section ?????
<include src="http://www.ietf.org/rfc/rfc1945" />
