Search results

Create the page "Mission phases" on this wiki! See also the search results found.

• LFI design, qualification, and performance
  ...t 1/<i>f</i> noise, the Low Frequency Instrument (LFI) on board the Planck mission acquired data at a rate much higher than the data rate allowed by the scien ...tegration of the LFI and HFI instruments onto the satellite. The first two phases were carried out at the Thales Alenia Space - Italia laboratories located i
  50 KB (7,826 words) - 22:29, 4 February 2015
• Operational history
  The major operational phases and milestones are: ...g, or ∼40% of initial tank loading) of fuel remaining on board at end of mission operations.
  11 KB (1,616 words) - 12:31, 26 March 2014
• Simulation data
  ...y, by astrophysical component, and of that sky as seen by Planck (fiducial mission realizations), together with separate sets of Monte Carlo realizations * 18000 full mission CMB simulations: 1000 for each of the nine Planck frequencies, and for two
  46 KB (7,032 words) - 12:02, 29 March 2016
• Timelines
  ...uantity giving the value of that quantity as a function of time during the mission. For LFI, refer to {{PlanckPapers|planck2014-a03}}, and for HFI, to {{Plan ...nstrument dependent) detector sampling frequency and span the full science mission. They thus consist of a large amount of data. This section is concerned w
  28 KB (4,415 words) - 18:43, 21 August 2015
• HFIpreprocessingstatics
  Definition of the phases of the HFI mission: !align="left"| Nominal mission
  2 KB (182 words) - 10:38, 22 October 2012
• HFI operations
  ...tension mission phase. Apart from ground based tests, different operations phases occurred, as listed below. ...f the HFI parameters were executed in-flight until the end of the full HFI mission, except in December 2009 for an adjustment of the on-board numerical compre
  2 KB (308 words) - 09:43, 3 February 2015
• HFI operations timeline
  ...FI instrument operations (when this is during the commissioning of the CPV phases, labels are usually followed by the activity label); * '''period''', refers to the different phases of the mission;
  27 KB (2,766 words) - 19:41, 11 December 2014
• LFIAppendix
  ...e bandwidths are critical for the high sensitivity required for the Planck mission. Some LNAs within the FEMs met the goals at 30 GHz and 44 GHz within the me ...near polarization performance of the FEMs exceeded the requirements of the mission. The isolation between the <i>E</i>- and <i>H</i>- polarizations was measur
  60 KB (9,314 words) - 08:48, 2 January 2015
• Planck operational state history
  ...mmary of the status of the Planck spacecraft, throughout the course of its mission. It should be useful to scientists as a complement to the data they are ana ...sily accessible way at any given time. States included are the operational phases and the operational status/mode of each of the major payload components. Th
  2 KB (401 words) - 15:20, 22 May 2014