Difference between revisions of "Simulation data"

From Planck PLA Wiki
Jump to: navigation, search
Line 56: Line 56:
 
---------------------
 
---------------------
  
The PST consists of 3 distinct pipelines that are used to generate the fiducial sky realization, the CMB MC and the noise MC respectively.
+
Since the full focal plane (FFP) simulations
 +
* involve both HFI and LFI data
 +
* include large, computationally challenging, MC realization sets
 +
they cannot be generated using either DPC's single-instrument cluster-based pipeline. Instead the PST consists of three distinct tool chains, each designed to run on the largest available supercomputers, that are used to generate the fiducial sky realization, the CMB MC, and the noise MC respectively. FFP6 was generated using the Hopper and Edison systems at [http://www.nersc.gov NERSC] and the Louhi system at [http://www.csc.fi/english CSC].
 +
 
 +
 
  
 
== Fiducial Sky ==
 
== Fiducial Sky ==

Revision as of 20:34, 13 March 2013

Introduction[edit]

The 2013 Planck data release is supported by a comprehensive set of simulated maps, including both a fiducial realization of the sky as seen by Planck and 1000-realization Monte Carlo (MC) sets of CMB and noise simulations, collectively known as FFP6.

The simulation process consists of

  • modeling the sky using pre-Planck data and generating an input sky map for each sky component for each detector that incorporates our best estimate of that detector's band-pass
  • simulating each detector's observation of each input sky component, following the Planck scanning strategy and using our best estimates of the detector's beam and noise properties, and mapping the results.
  • generating Monte Carlo realizations of the CMB and noise maps, again following the Planck scanning strategy and using our best estimates of the detector beams and noise properties respectively.

The first step is done by the Planck Sky Model (PSM), and the second and third by a suite of Planck Simulation Tools (PST). A brief description of these is given below.

The Planck Sky Model[edit]


The Planck Sky Model, a complete set data and code to simulate sky emission at millimeter-wave frequencies, is described in detail in the pre-launch PSM paper (Delabrouille et al., arXiv/1207.3675).

The main simulations used to test and validate the Planck data analysis pipelines (and, in particular, component separation) makes use of simulations generated with version 1.7.7 of the PSM software. Sky emission comprises the following components: CMB, thermal dust, spinning dust, synchrotron, CO lines, free-free, thermal Sunyaev-Zel'dovich (SZ) effect (with first order relativistic corrections), kinetic SZ effect, radio and infrared sources, Cosmic Infrared Background (CIB).

The CMB is a based on adiabatic initial perturbations, with the following cosmological parameters:

  • T_CMB = 2.725
  • H = 0.684
  • OMEGA_M = 0.292
  • OMEGA_B = 0.04724
  • OMEGA_NU = 0
  • OMEGA_K = 0
  • SIGMA_8 = 0.789
  • N_S = 0.9732
  • N_S_RUNNING = 0
  • N_T = 0
  • R = 0.0844
  • TAU_REION = 0.085
  • HE_FRACTION = 0.245
  • N_MASSLESS_NU = 3.04
  • N_MASSIVE_NU = 0
  • W_DARK_ENERGY = -1
  • K_PIVOT = 0.002
  • SCALAR_AMPLITUDE = 2.441e-9

All other parameters are set to the default standard of the Jan 2012 version of CAMB. In addition, this simulated CMB contains non-Gaussian corrections of the local type, with an f_NL parameter of 20.4075.

The Galactic ISM emission comprises 5 major components: Thermal dust, spinning dust, synchrotron, CO lines, and free-free emission. We refer the reader to the PSM publication for details. For the simulations generated here, however, the thermal dust model has been modified in the following way: Instead of being based on the 100 micron map of Schlegel, Finkbeiner and Davis (SFD; 1998), the dust template uses an internal release of the 857 GHz Planck observed map itself, in which point sources have been subtracted, and which has been locally filtered to remove CIB fluctuations in the regions of lowest column density. A caveat is that while this reduces the level of CIB fluctuations in the dust map in some of the regions, in regions of moderate dust column density the CIB contamination is actually somewhat larger than in the SFD map (by reason of different emission laws for dust and CIB, and of the highr resolution of the Planck map).

The other emissions of the galactic ISM are simulated using the prescription described in the PSM paper. Synchrotron, Free-free and spinning dust emission are based on WMAP observations, as analyzed by Miville-Deschenes et al., 2008. Small scale fluctuations have been added to increase the variance on small scales and compensate the lower resolution of WMAP as compared to Planck (in particular HFI channels). The main limitation of these maps is the presence at high galactic latitude of fluctuations that may be imputable to WMAP noise. The presence of noise and of added Gaussian fluctuations on small scales may result in a few occasional pixels being negative (e.g. in the spinning dust maps). Low frequency foreground maps are also contaminated by some residuals of bright radio sources that have not been properly subtracted from the templates of diffuse emission.

The CO maps are simulated using the CO J=1-0 observations of Dame et al. (2001). The main limitations are limited sky coverage, lower resolution than that of Planck high frequency channels, line ratios (J=2-1)/(J=1-0) and (J=3-2)/(J=2-1) constant over the sky. The CO in the simulation is limited to the three lowest 12CO lines.

Galaxy clusters are generated on the basis of cluster number counts, following the Tinker et al. (2008) mass function, for the cosmological parameters listed above. Clusters are assumed perfectly spherical, isothermal, and are modeled using the universal pressure profile of Arnaud et al. (2010). Relativistic corrections following Itoh et al. (1998) are included to first order. The simulated kinetic SZ effect assumes no bulk flow, and a redshift-dependent average cluster velocity compatible with the linear growth of structures.

Point sources comprise radio sources (based on extrapolations across frequencies of radio observations between 800 MHz and 5 GHz) and infrared sources (based on extrapolations in frequencies of IRAS sources). One small caveat that should be mentioned is that because of the unevenness of the radio source surveys, the equatorial southern part of the sky has less faint radio sources than the northern part. Although all the missing sources are well below the Planck detection level, this induces a small variation of the total emission background over the sky. Check the individual faint point source emission maps if this is a potential problem for your applications. See also the PSM publication for details about the PSM point source simulations.

Finally, the far infrared background due to high redshift galaxies has been simulated using a procedure is based on the distribution of galaxies in shells of density contrast at various redshifts (Castex et al., PhD thesis; paper in preparation). This simulation has been modified by gradually substituting an uncorrelated extra term of CIB emission at low frequencies, artificially added in particular to decorrelate the CIB at frequencies below 217 GHz from the CIB above that frequency, to mimic the apparent decorrelation observed in the Planck Early Paper on CIB power spectrum.

While the PSM simulations described here provide a reasonably representative multi-component model of sky emission, the users are warned that it has been put together mostly on the basis of data sets and knowledge pre-existing the Planck observations themselves. While it is sophisticated enough to include variations of emission laws of major components of ISM emission, different emission laws for most sources, and a reasonably coherent global picture, it is not (and is not supposed to be) identical to the real sky emission. The users are warned to use these simulations with caution.

The Planck Simulation Tools[edit]


Since the full focal plane (FFP) simulations

  • involve both HFI and LFI data
  • include large, computationally challenging, MC realization sets

they cannot be generated using either DPC's single-instrument cluster-based pipeline. Instead the PST consists of three distinct tool chains, each designed to run on the largest available supercomputers, that are used to generate the fiducial sky realization, the CMB MC, and the noise MC respectively. FFP6 was generated using the Hopper and Edison systems at NERSC and the Louhi system at CSC.


Fiducial Sky[edit]

For each detector, fiducial sky time-ordered data are generated separately for each of its 10 PSM component maps and its strong point source catalogue using the LevelS software (ref) as follows:

  • The detector's beam and PSM map are converted to spherical harmonics using beam2alm and anafast respectively.
  • The beam-convolved map value is calculated over a 3-dimensional grid of sky locations and beam orientations using conviqt.
  • The map-based time-ordered data are calculated sample-by-sample by interpolating over this grid using "multimod".
  • The catalogue-based time-ordered data are calculated sample-by-sample by beam-convolving any point source laying within a given angular distance of the pointing at each sample time using multimod.

For each frequency, fiducial sky maps are generated for

  • the total sky (including noise),
  • the foreground sky (excluding CMB but including noise),
  • the point source sky, and
  • the noise alone

All maps are made using the MADAM destriping map-maker (ref) interfaced with the TOAST data abstraction layer. In order to construct the total time-ordered data required by each map, for each detector TOAST reads the various component time-streams separately and sums then, and, where necessary, simulates and adds a noise realization time-stream on the fly.

HFI frequencies are mapped at HEALPix resolution nside=2048 using ring-length destriping baselines, while LFI frequencies are mapped at nside=1024 using 1s baselines.

CMB Monte Carlo[edit]

The CMB MC set is generated using FEBeCoP, which generates an effective beam for each pixel in a map at each frequency by accumulating the weights of all pixels within a fixed distance of that pixel, summed over all observations by all detectors at that frequency. It then applies this effective beam pixel-by-pixel to each of 1000 input CMB sky realizations. These 1000 CMB realizations are drawn as Gaussian realizations of which set do we cite? multiple sets?.

Noise Monte Carlo[edit]

The noise MC set is generated just as the fiducial noise maps, using MADAM/TOAST. In order to avoid spurious correlations within and between the 1000 realizations, each stationary interval for each detector for each realization is generated from a distinct sub-sequence of a single statistically robust, extremely long period, pseudo-random number sequence.

Products delivered[edit]


What follows is the plan for the sims to be delivered as of mid Jan 2013. The text below is to be replaced by the description of the products described (AMo - 7/3/13)


Modeled sky (PSM outputs)[edit]

Full channel / nominal mission sky maps, Temperature only, in 9 Planck bands, of 10 components: cmb (lensed), CO, FIRB, free-free, synchrotron, thermal dust, spinning dust, kinetic SZ, thermal SZ, point sources

==> 10x9 maps for all components except CO) + 6 CO maps (present at freq > 100 GHz only) for a total of 96 maps which are to be grouped by frequency (as SkyMap products, into 10 FITS files, one for each component, names like COM_PSMMap-{component)_Nside_Relname.fits


Observed sky[edit]

A nominal mission map for each of the following

  • a total map, i.e., sum of all components + noise
  • a foregrounds map, i.e., sum of all components except cmb, including noise
  • a point sources map, with the point sources alone
  • the noise maps, with the noise alone

==> for a total of 36 maps grouped into 4 FITS files. Names like COM_SimMap-{total | foregrounds | sources | noise)_Nside_Relname.fits

Cosmic Microwave background

Planck Sky Model

Sunyaev-Zel'dovich

(Planck) High Frequency Instrument

(Planck) Low Frequency Instrument

Data Processing Center

(Hierarchical Equal Area isoLatitude Pixelation of a sphere, <ref name="Template:Gorski2005">HEALPix: A Framework for High-Resolution Discretization and Fast Analysis of Data Distributed on the Sphere, K. M. Górski, E. Hivon, A. J. Banday, B. D. Wandelt, F. K. Hansen, M. Reinecke, M. Bartelmann, ApJ, 622, 759-771, (2005).

Flexible Image Transfer Specification