HFI systematic effects

From Planck Legacy Archive Wiki
Revision as of 07:21, 18 January 2019 by Mlopezca (talk | contribs)
Jump to: navigation, search


Like all experiments, Planck HFI had a number of specific issues that needed to be tracked to verify that they were not compromising the data. While these are discussed in appropriate sections, here we gather the systematic effects affecting the TOIs together to give brief summaries of the issues and refer the reader to the appropriate sections for more details.

  • Cosmic rays – unprotected by the atmosphere and more sensitive than previous bolometric experiments, HFI saw many more cosmic ray hits than its predecessors. These were detected, the worst parts of the data flagged as unusable, and "tails" were modelled and removed. This is described in the section on glitch statistics as well as in the 2013 HFI glitch removal paper[1]. An estimate of the level and effect of remaining undetected glitches is described in Planck-2020-A3[2].
  • "Elephants" – cosmic rays also hit the HFI 100-mK stage and cause the temperature to vary, inducing small temperature and thus noise variations in the detectors. These elephants are removed from the timelines with the rest of the thermal fluctuations, described directly below.
  • Thermal fluctuations – HFI is an extremely stable instrument, but there are small thermal fluctuations. These are discussed in the timeline processing section on thermal decorrelation.
  • Random telegraphic signal (RTS) or "popcorn noise" – some channels were occasionally affected by what seems to be a baseline that abruptly changes between two levels, which has been variously called popcorn noise or random telegraphic signal. These data are usually flagged. This is described in the section on noise stationarity.
  • Jumps – similar to (but distinct from) popcorn noise, small jumps were occasionally found in the data streams. These jumps are usually corrected, as described in the section on jump corrections.
  • 4-K cooler-induced EM noise – the 4-K cooler induced noise in the detectors with very specific frequency signatures, which can be filtered. This is described in the 2013 HFI DPC Paper[3]; their stability is discussed in the section on 4-K cooler line stability.
  • Compression – on-board compression is used to overcome our telemetry bandwidth limitations. This is explained in Planck-Early-IV[4]and an analysis of this effect in maps is described in Planck-2020-A3[2].
  • ADCPlanck-2013-VII[5] reported that the HFI raw data show apparent gain variations with time of up to 2% due to nonlinearities in the HFI readout chain. In the 2013 data release (Planck-2013-VIII[6]) a correction for this systematic error was applied as an apparent gain variation at the map making stage. The 2013 maps relied on an effective gain correction based on the consistency constraints from the reconstructed sky maps, which proved to be sufficient for the 2013 cosmological analysis based on temperature only. For the 2015 data release we have implemented a direct ADC correction in the TOI. The ADC effect and its correction, and its validation through end-to-end simulations are described in sections 2 and 5 of [7]. An improved correction for the ADC affect using the SRoll map-making algorithm was implemented for the 2018 release, and is described in Planck-2016-XLVI[8] and Planck-2020-A3[2].
  • Noise correlations – correlations in noise between detectors seems to be negligible, except for two polarization-sensitive detectors in the same horn. This is discussed in the 2013 HFI Glitch removal paper[1].
  • Pointing and Focal Plane geometry – the final pointing reconstruction for Planck is near the arcsecond level, as discussed in the 2013 HFI DPC Paper[3] and in Planck-2013-I[9]. The relative positions of different horns in the focal plane are reconstructed using planets. This is also discussed in the 2013 HFI DPC paper[3]. An improved reconstruction of the focal plane directions was used for the 2015 and 2018 releases and is described in Planck-2015-A01[10].
  • Main beam – the main beams for HFI are discussed in the 2013 Beams and Transfer function paper[11] and an improved analysis for the 2015 release is presented in Planck-2015-A07[12].
  • Ruze envelope – random imperfections, or dust on the mirrors, can mildly increase the size of the beam. This is discussed in the 2013 Beams and Transfer function paper[11].
  • Dimpling – the mirror support structure causes a pattern of small imperfections in the beams, which generate small sidelobe responses outside the main beam. This is discussed in the the 2013 Beams and Transfer function paper[11].
  • Far sidelobes – small amounts of light can sometimes hit the detectors from just above the primary or secondary mirrors, or even from reflections off the baffles. While small, when the Galactic centre is in the right position, this can be detected in the highest frequency channels, and so is removed from the data. This is discussed in the 2013 Beams and Transfer function paper[11] and also in the 2013 Zodiacal emission paper[13] for 2013, in Planck-2015-A08[14] for 2015 and in Planck-2020-A3[2] for 2018.
  • Planet fluxes – comparing the known flux densities of planets with the calibration on the CMB dipole is a useful check of calibration for the CMB channels, and is the primary calibration source for the submillimetre channels. This is done in the 2013 Mapmaking and Calibration paper[6]. In Planck-2020-A3[2] the planet-based calibration at 545 and 857 GHz is compared to the dipole-based calibration. The best estimate of planet fluxes is presented in Planck-2017-LII[15].
  • Point source fluxes – as with planet fluxes, we also compare fluxes of known, bright point sources with the CMB dipole calibration. This is done in the 2013 Mapmaking and Calibration paper[6].

The systematic effects affecting the maps were corrected in open loop in the 2015 release, using ground measurements and modelisation. For the 2018 release, almost all known systematics affecting the maps have been corrected. Using together ground-based and extracted-from-the-sky determination of the parameters of these systematic effects, we correct these at the mapmaking level using the SRoll generalized polarized destriper.

A full description of the remaining systematic effects is included in Planck-2020-A3[2]. The two figures below extracted from that paper provide a snapshot of the levels of the main effects remaining in the 2018 polarization maps, estimated using realistic simulations and/or jack-knife tests on the data itself.

Screen Shot 2018-07-03 at 09.59.26.png
Screen Shot 2018-07-03 at 10.00.18.png


References[edit]

  1. 1.01.1 Planck 2013 results. X. HFI energetic particle effects: characterization, removal, and simulation, Planck Collaboration, 2014, A&A, 571, A10.
  2. 2.02.12.22.32.42.5 Planck 2018 results. III. High Frequency Instrument data processing and frequency maps, Planck Collaboration, 2020, A&A, 641, A3.
  3. 3.03.13.2 Planck 2013 results. VI. High Frequency Instrument Data Processing, Planck Collaboration, 2014, A&A, 571, A6.
  4. Planck early results, IV. First assessment of the High Frequency Instrument in-flight performance, Planck HFI Core Team, A&A, 536, A4, (2011).
  5. Planck 2013 results. VII. HFI time response and beams, Planck Collaboration, 2014, A&A, 571, A7.
  6. 6.06.16.2 Planck 2013 results. VIII. HFI photometric calibration and Map-making, Planck Collaboration, 2014, A&A, 571, A8.
  7. Planck intermediate results. XLVI. Reduction of large-scale systematic effects in HFI polarization maps and estimation of the reionization optical depth, Planck Collaboration Int. XLVI A&A, 596, A107, (2016).
  8. Planck 2013 results. I. Overview of Products and Results, Planck Collaboration, 2014, A&A, 571, A1.
  9. Planck 2015 results. I. Overview of products and results, Planck Collaboration, 2016, A&A, 594, A1.
  10. 11.011.111.211.3 Planck 2013 results. IX. HFI spectral response, Planck Collaboration, 2014, A&A, 571, A9.
  11. Planck 2015 results. VII. High Frequency Instrument data processing: Time-ordered information and beam processing, Planck Collaboration, 2016, A&A, 594, A7.
  12. Planck 2013 results. XIV. Zodiacal emission, Planck Collaboration, 2014, A&A, 571, A14.
  13. Planck 2015 results. VIII. High Frequency Instrument data processing: Calibration and maps, Planck Collaboration, 2016, A&A, 594, A8.
  14. Planck intermediate results. LII. Planets flux densities, Planck Collaboration Int. LII A&A, 607, A122, (2017)

(Planck) High Frequency Instrument

random telegraphic signal

analog to digital converter

Cosmic Microwave background